Registry
Module Specifications
Archived Version 2020 - 2021
| |||||||||||||||||||||||||||||||||||||||||||||
Description To provide knowledge of pneumatic, hydraulic and PLC systems. To analyse compressors, hydraulic power packs, and distribution networks, directional control valves, signal valves and actuators. Introduction to PLC systems and control of circuits. | |||||||||||||||||||||||||||||||||||||||||||||
Learning Outcomes 1. Analyse and solve a range of Pneumatic and Hydraulic problems 2. Build pneumatic circuits using a range of standard pneumatic components 3. Describe factors to be considered when designing pneumatic and hydraulic circuits 4. Specify air treatment equipment and hydraulic power packs 5. Design simple programmes to control the operation of pneumatic circuits 6. Programme a standard PLC and test/fault find | |||||||||||||||||||||||||||||||||||||||||||||
All module information is indicative and subject to change. For further information,students are advised to refer to the University's Marks and Standards and Programme Specific Regulations at: http://www.dcu.ie/registry/examinations/index.shtml |
|||||||||||||||||||||||||||||||||||||||||||||
Indicative Content and
Learning Activities Reciprocating compressors and effect of clearance volumePsychometry, compressed air drying and air distributionPneumatic circuit components, symbols and circuit designCascade systems and sequential controlHydraulic system components, symbols and circuit designHydraulic fluids contamination control and filtersHydraulic system maintenanceIntroduction to PLC,sProgramming of PLC,sWorked Examples of circuits and programs | |||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||
Indicative Reading List
| |||||||||||||||||||||||||||||||||||||||||||||
Other Resources None | |||||||||||||||||||||||||||||||||||||||||||||
Programme or List of Programmes | |||||||||||||||||||||||||||||||||||||||||||||
Archives: |
|